How To Apply Wood Filler To Log Siding

If you don t have a tube use a putty knife to apply it.

How to apply wood filler to log siding. Dig out all the rot from inside the crack or hole with an awl or a flat head screwdriver. Sand the edges of the. Mix it first according to the instructions on the container. Now use a two part epoxy based wood filler to fill the holes.

It is best to fill in two or three steps rather than try to fill a deep hole in one pass. Cut the foundation log sidings to fit between the corner logs. These epoxy fillers set up fast so only mix what you can use within 15 minutes. Make sure you install the foundation log along the bottom of the wall.

While tooling scrape the excess sealant from the sharp edges of the check and remove any material that may have smeared over the surfaces of the adjoining logs with a wet rag or sponge. Once your wood filler is mixed use it quickly. Fill the crack completely then scrape the excess from the. Apply the wood filler using a putty knife.

Correct way to apply wood filler to exterior siding 1. Use the tube to squeeze the filler into the area making sure to fill in the deepest area by pressing the end down into it. 6 then using a putty knife shaped piece of wood or a finger tool the bead to further force the sealant into intimate log contact. Apply the filler to the craft sticks using another craft stick or a putty knife.

The best substances for plugging holes and filling cracks with this old house general contractor tom silva. The craft sticks will act as a support for the wood filler. Subscribe to this old house. Start at the edge of the damaged area pressing the wood filler into the depression.

Squeeze the filler into the hole. Start at one end and gradually work your way to the other end. Cut and install the foundation log. Attach the log sidings to your studs using the 3 inch lag screws.

Leave a inch space between the floor and the log siding as well as the ceiling and the log siding. Apply epoxy wood filler with a putty knife as an alternative to using caulk. Overfill slightly to allow for the fact that the filler. The filler should be level and even with the surface of the wood.