How For Put Nail On The Felt In Roll Roofing

Start the roof felt at one bottom corner of the roof.

How for put nail on the felt in roll roofing. Secure the outside edges with plastic capped roofing nails at 12 inch intervals. The entire length of the valley should be covered with a sheet of roll roofing that is at least 18 inches wide. Apply rolled roofing rolled roofing has become more and more popular in recent years. When compared to shingles rolled roofing is far cheaper and much easie.

Tack it in place at the corner with the end flush with the end of the roof and the bottom edge of the roll right along the bottom of the roof. Roll the roof paper up and over the peak. Use 1 inch nails for new roofing. Repeat this until the entire roof is.

Nail the roofing in place with short roofing nails spaced 6 inches apart and 1 inch in from the outer edges of the roll roofing. Step 5 secure ends. Nail the two rolls in the overlap at 12 inch intervals. An underlayment of felt roofing is optional.

Use a trowel to spread roofing cement over half or more of the strips. In roofing one square equals 100 square feet. You will need 1 10 gallon of lap not mastic cement for every roll and 2 pounds of roofing nails for every square. Step 3 nail down the 18 inch roll roofing sheet that it is covering the valley.

All nails and staples should be placed on the lower half of the paper. They are long enough to penetrate the sheathing. The paper should then be nailed in or stapled every three to four inches across. Place this roofing material so it straddles the valley.

The overhang to the next strip should be 3 8 inch. The nails should start 3 4 inch from the edges of the roofing and be 6 inches apart throughout the roofing s surface. Where a roll ends and a new one is begun the two rolls should be overlapped by four inches.