How Do I Split Up The Joints In Siding

Use a felt paper spline wrapped around the corner and extending 6 inches beyond the corner board to protect the joints where the siding meets the corner boards see figure 1 5 at left.

How do i split up the joints in siding. Z flashing fits between the. Lay out the remaining panels to ensure the joints do not overlap in the same vertical plane as the course below. I am planning cut out damaged sections of siding and replace with new boards priming all bare wood and flashing behind the butt joints with bituthene. Cut a new shorter siding panel and start the second course with this shorter piece.

Butt joints are a perfect example of poor joint design they re too small to accommodate a bond breaker so the caulk can t stretch properly once applied but they re also too large to simply leave alone. Stagger the siding end laps so that no two courses rows of panels are aligned vertically unless separated by at least three courses. A lot of moisture from rain snow misdirected sprinklers or exuberant water fights can get in there enough to do some serious and expensive damage. Avoid using panels shorter than 24 610mm.

The thing i should have indicated is they are only about 1 4 tall and you have to drive a little shim under both pieces of the siding to the left and the right of the joint so that the dog ears don t drag too much on the siding and flatten out. Always overlap joints away from entrances and or away from the point of greatest traffic. Got a hole in your vinyl siding and want to patch it quickly. Place a full length piece of the damaged siding on the face of the replacement.

Use a square length of 5 4 stock at inside corners with a spline underneath. I am replacing damaged split 1 8 v rustic wood siding. This will improve the overall appearance of the installation fig. Be careful not to split the old wood.

Scoring prevents the wood from chipping when you cut it. You can patch a hole in your vinyl siding in less than three minutes using tear aid type b from. The dog ears show about as good as i can do in the pictures. If the siding was installed correctly you should see a piece of z metal flashing at the butt joint of the two pieces of siding.