How Do I Make A Roof Rake

I have to say it worked great i used the metal part face down not the rubber part.

How do i make a roof rake. How to make a roof rake step 1. The roof rake plates are installed in different widths depending on the surface being covered. Use larger rake plates such as 1 by 4 inches and 1 by 6 inches when there is an infinity ledge at the end of the gable. An added bonus was that i could use one end of.

When the snow started to pile up on handyman bill. Use your clamp to attach the two 4 inch brackets to one end of the aluminum pole positioning one angled bracket on each side. Here s what i came up with. Measure and place a mark 2 from an end.

Use the drill to make a hole in the aluminum pole using the bracket holes as a guide. Begin by cutting two 12 sections from one on the 1 x 10 pvc pipes. Make this easy avalanche roof rake for the winter and let a clever diy design do all the work for you. I used the driveway sealer squeegee and an extension pole to work as a snow roof rake.

On the 1 x 12 arms where you placed the marks in the previous step use the hole saw to bore straight through. Make sure the holes on the brackets are lined up and are angled at 90 degrees. Insert your 2 1 2 inch. Attach the two 4 inch angle brackets to the end of your aluminum pole.

Drill straight through the aluminum handle through one bracket hole to the hole on the other side using your. Rake plates of one by 2 inches often cover the exposed top edge of the liner when there is also a ledge at the end of the gable.